I had a feeling I forgot to write...
I wasn't paying too much attention, so I glued the fin a bit angled than the other ones, but it still works, just slightly unbalanced. I also had to put the filter on the exhaust side of the fan since the fan was rubbing against the filter mesh.
While I know it'll hold, I think I want to perhaps replace the fan when I'm able to, just so I have some piece of mind.
I also found a different fan filter that has a cross frame so the mesh doesn't get sucked into the fan, wish I saw that earlier, since I would've bought that instead. But I'll eventually get one to swap that one out with (putting it on the intake side, obviously) and then using the filter to cover the PSU, since I dropped a screw into it once.... and had an annoying time getting it out.
No comments:
Post a Comment